Avaya S8300 - Manual (Page 522)

Manual installation of a new G700 with an S8300
522 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
Figure 49: Add Local Survivable Processor screen
2. The type field is automatically populated with LSP. LSP appears in the field if the node
name is not associated with ESS.
3. Enter a network region for the LSP. The default is 1. However, there may be a different
network region better suited for the LSP to provide media gateway and IP phone support.
Skip to Administering the Media Gateway on page 532.
Administering an S8400, S8500, or S8700-series primary
controller
In this case, the S8300 you have installed is configured as an LSP.
!
CAUTION:
CAUTION:
This administration applies only to the primary controller that controls the S8300
LSP that you are installing. The primary controller can be an S8400, S8500, or
S8700-series Media Server. Do not administer the S8300 LSP. Translations are
automatically copied to the LSP from the primary controller.
Skip this section and go to Administering an S8300 primary controller on page 516 if the
primary controller is an S8300.
Note:
Note:
Some of the procedures in this section may have been completed previously as
part of a normal media server installation.
This document covers only the administration of Communication Manager required for the
G700 media gateway to communicate with the primary controller over a customer’s network.
For the majority of required administration, see Administrator Guide to Avaya Communication
Manager, 03-300509, or Administration for Network Connectivity for Avaya Communication
Manager, 555-233-504.
add survivable-processor sv-mg2-lsp Page 1 of xx
SURVIVABLE PROCESSOR - PROCESSOR ETHERNET
Node Name: sv-mg2-lsp
IP Address: 128.256.173.101
Type: LSP
Network Region: 1