Avaya S8300 - Manual (Page 678)

Manual upgrade of an existing S8300B and G700 to R3.1
678 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
To save translations
1. At the SAT prompt, type save translation and press Enter.
2. Under Command Completion Status you should see Success.
To disable alarm origination
If alarm origination is enabled during the upgrade, unnecessary alarms will be sent to the
Operations Support System (OSS) destination number(s). Even if you selected Suppress
Alarm Origination when you logged in, alarm origination will be automatically re-enabled when
the system reboots after the software upgrade. Use this procedure to prevent alarm origination
from being re-enabled after reboot.
!
CAUTION:
CAUTION:
If you do not disable alarm origination, the system can generate alarms during
the upgrade, resulting in unnecessary trouble tickets.
1. Logoff the SAT session.
2. At the command prompt, type almenable -d n -s n, where
-d n sets the dialout option to neither (number)
-s n disables SNMP alarm origination
Note:
Note:
Be sure to reset alarm origination after the upgrade.
3. Type almenable (without any options) to verify the alarm origination status.
You should see:
incoming: enable
Dial Out Alarm Origination: neither
SNMP Alarm Origination: n
Saving a copy of the 4600-series phone configuration file, if any
During an upgrade, any data in the /tftpboot directory is overwritten with new software and
firmware. If the system was using the http or tftp capability for 4600-series phone firmware
downloads and configuration updates, the firmware and 4600-series phone configuration file
are overwritten.
You must redownload the 46xx firmware file after the upgrade. However, you can save a copy of
the 46xx configuration file before the upgrade and copy it back into the /tftpboot directory after
the upgrade.