Avaya S8300 - Manual (Page 76)

Roadmaps and reference information
76 Installing and Upgrading the Avaya G700 Media Gateway and Avaya S8300 Media Server
Open the Communication Manager SAT Screens
To run SAT:
1. If you already have a valid telnet session in progress, access the SAT program by typing sat
or dsat at the telnet prompt.
Or, to open SAT directly from your laptop:
a. Run PuTTY or another SSH client.
b. Use IP address 192.11.13.6 and port number 5023.
2. Log in to the Communication Manager as craft or dadmin.
Enter your login confirmation information as prompted:
- Password prompt—Type your password in the Password field, and click Login or press
Enter again.
- ASG challenge—If the login is Access Security Gateway (ASG) protected, you will see a
challenge screen. Enter the correct response and click Login or press Enter.
3. Enter your terminal type.
Accept the default value, or enter the appropriate type for your computer. For example, you
may use type ntt, a terminal type available for Windows NT4.0 or Windows 98. For
Windows 2000, use w2ktt.
The system displays the SAT interface.
4. Enter SAT commands as appropriate.
Logging in to the P330 Stack Processor with a
Direct Connection to the S8300 Services Port
Note:
Note:
If you are upgrading an S8300/G700 remotely, connect to the customer LAN and
telnet to the IP address of the P330 stack master (that is, the P330 Stack
Processor running as the stack master). The IP address is the address assigned
on the customer LAN, not 192.11.13.6.
To log in with a direct connection to the S8300 services port:
1. With a direct connection to the S8300 services port, SSH to the S8300 IP address with
PuTTY or another SSH client, using the IP address 192.11.13.6.
2. Login as craft or cust.
3. Telnet to the P330 stack master stack processor.
Type telnet <xxx.xxx.xxx.xxx>, where <xxx.xxx.xxx.xxx> is the IP address of
the P330 stack master processor on the customer’s LAN.