Summers Superchisel - 3-Section - Manual (Page 13)

SECTION 2 – ASSEMBLY INTRODUCTION
GENERAL ASSEMBLY SAFETY PRACTICES
1. READ AND UNDERSTAND Operator’s Manual before assembly of machine.
2. Machine should be assembled in a horizontal (field) position only.
3. If machine is to be assembled INDOORS, check that exit door is a MINIMUM OF 20’6”
WIDE. Height requirement varies from 10’8” to 18’0”. Shanks may be left off to reduce
height and width requirement.
4. Reference to “RIGHT” and “LEFT” is determined when machine IS VIEWED FROM THE
REAR.
5. Reference to “FORWARD” means TOWARDS THE TRACTOR.
6. Reference to “REAR” means AWAY FROM THE TRACTOR.
SAFETY-ALERT SYMBOL
This symbol is an alert to the potential
for personal injury. This symbol means
ATTENTION! BECOME ALERT!
YOUR PERSONAL SAFETY IS INVOLVED!
2-1