Summers Superchisel - 3-Section - Manual (Page 38)

2-26
SECTION 2 – SET-UP OF CENTER SECTION (32’-44’)
11. Attach wing transport locks to center frame with 3/4” u-bolts.
– Located outside edge of bolt plate 78-3/8” away from frame center.
– Install 1/2 x 6” pins in inside storage holes of transport lock.
12. Insert 1-1/2 x 10-3/8” eyebolts into wing lift cylinder attach base.
– Leave 1-1/2” nuts loose, they will need to be adjusted after wing is installed.
13. Attach wing lift cylinders to frame with pins and roll pins.
– 32’ through 36’ machines use 4 x 36” cylinders (8K9640).
– 38’ through 44’ machines use 5 x 36” cylinders (8K9650).