Summers Superchisel - 3-Section - Manual (Page 64)

2-52
SECTION 2 – HYDRAULIC SET-UP (32’-44’)
6. Charge Wing Lift Cylinders.
– Block rod end of cylinders so cylinders can extend without hitting anything.
– Fully cycle the cylinders several times to make sure that all air has been removed from sys-
tem.
– Leave cylinders in fully extended position.
7. Connect rod end of cylinders to wing. Follow these steps and see drawing below.
– Use pivot bolt, washers with collars, 1-1/4” washers, 1” washer and 1” lock nut provided.
– 1-1/4” washers must slide freely inside wing flamecuts.
– Do not over tighten lock nut. Pivot bolt must rotate freely.