Summers Superchisel - 3-Section - Manual (Page 54)

2-42
SECTION 2 – SET-UP OF 40’ BASE MACHINES (40’-44’)
22. Install shanks into trip assemblies.
– Install rear 3/4 x 4” bolt. Slide shank into shank holder. Install front bolt. Securely tighten.
– Shanks will fit snuggly into shank holder. If tapping bottom of shank does not work, it may
be necessary to remove burr and/or paint from shank or shank holder.
31” STD
34” OPT