Summers Superchisel - 3-Section - Manual (Page 58)

SECTION 2 – HYDRAULIC SET-UP (16’-30’ NARROW)
2-46
M. Tighten all plastic hose clamps until hoses are snug but not compressed. Over tightening
hose clamps will damage hydraulic hose. Hydraulic hoses enlarge and shorten when pres-
surized, leave slack between clamps.
N. Charge Wing Lift Cylinders.
– Block rod end of cylinders so cylinders can extend without hitting anything.
– Fully cycle the cylinders several times to make sure that all air has been removed from
system.
– Leave cylinders in fully extended position.
O. Connect rod end of cylinders to wing. Follow these steps and see drawing on Page 2-52.
– Use pivot bolt, washers and collars, 1-1/4” washers, 1” washer and 1” lock nut provided.
– 1-1/4” washers must slide freely inside wing flamecuts.
– Do not over tighten lock nut. Pivot bolt must rotate freely.
P. With cylinder attach eyebolts loose, raise chisel plow wings to transport position.
– Fully retract cylinders and let wings rest against transport locks.
– Tighten each eyebolt so pivot bolt and rollers are centered in the wing lift slot.
WING LFT HYD 2/9/2012 9T2412N.iam/
8J6030
7/8"X#10(M) 90° ADP
8J5300
#6 JIC(M) TEE
8J5700
#6 JIC(F-SW) X #6 JIC(M) 90° ADP
8J5510
3/4" ORB X #6 JIC(M)
8D3212
3/4" ORB TIP ISO
8D9524
5.0" X 24"
8J5300
#6 JIC(M) TEE
8J5700
#6 JIC(F-SW) X #6 JIC(M) 90° ADP
8N3360
3/8" X 360"
8N3028
3/8" X 28"
WING LIFT HYDRAULICS
24'-30' MACHINE
8D9525
SEAL KIT 5X24"
8A1954
1/4"OD TUBE - 18"
ARROW MUST
POINT TOWARD
CYLINDER
8J5200
#10(F)X#6(M) BUSH
8J5510
3/4" ORB X #6 JIC(M)
8J7040
THERMAL RELIEF
8J5680
3/4"X3/4" UNION
8J7116
8J5620
3/4" X #6 JIC (F-SW)
8J5200
#10(F)X#6(M) BUSH
8J6030
7/8"X#10(M) 90° ADP
8J6030
7/8"X#10(M) 90° ADP
8J5200
#10(F)X#6(M) BUSH
8J5620
3/4" X #6 JIC (F-SW)
8J7116
8J5510
3/4" ORB X #6 JIC(M)
8N3048
3/8" X 48"