Summers Superchisel - 3-Section - Manual (Page 25)

2-13
SECTION 2 – SET-UP OF WINGS (24’-30’NARROW)
NOTE: It is recommended to set up both sides of machine at the same time. The left hand side is
shown.
1. Attach wing to center section with pins, washers, bolts and locknuts.
– Washers (8C6015) are used to center wing in hinges and prevent shift.
2. Fasten cylinder attach brackets with 3/4” u-bolts.
– Locate brackets: 126 1/2” from center of machine.
3. Insert eyebolts (8K1755) into cylinder attach bracket.
– Tighten 1-1/2” nuts so the same amount of threads are above top nut on all eyebolts. Insure
that cylinder attach holes are aligned when eyebolts are tightened.
WING 3/19/2014 9T2412N.iam/
8T3600
8X0234
7/16" LNUT
8C6015
8X0044
7/16" X 3-1/2"
8X0285
1 1/2" N
q
8T4224
24', 26', 28' & 30' NARROW WING
8T4035 (24', 26', 28', 30' LEFT)
8T4037 (24', 26', 28', 30' RIGHT)
8X0286
1 1/2" JN
8K5515
3/4 X 4-1/16 X 6"
8X0260
3/4" N
8X0306
3/4" LW 8K1755