Summers Superchisel - 3-Section - Manual (Page 55)

2-43
SECTION 2 – HYDRAULIC SET-UP (16’-30’ NARROW)
1. Hydraulic hoses and fittings for depth control cylinders can be found on following drawings.
– Rephasing cylinders require that oil from the rod end of first cylinder goes to base end of
second cylinder and so forth. Cylinders will not operate properly unless they are connected
correctly.
2. Special attention should be paid to routing of hydraulic hoses. Page 2-50 shows layout of hoses
for depth control cylinders.
A. It is best to start by routing the hose for the 6 x 10” cylinder. Make sure there is 60” of hose
ahead of hose holder. This is usually enough hose for safe and easy hook-up to tractor.
B. Route hose along hitch frame. Use plastic clamps provided. Do not tighten until routing is
complete.
– On hitch, and a portion of main frame, 2 clamps are placed on each bolt.
– Clamps are made to have the round surface point towards the surface that you are
mounting to. DO NOT OVER TIGHTEN.
DISKCHSL-CLTRCHSL/DEPCONHYD 7/30/2012
8T1060
6.0" X 10"
8J5520
3/4"-16ORB X 10 JIC(M)
8J5520
3/4"-16ORB X 10 JIC(M)
8J5510
3/4"-16ORB X 6 JIC(M)
8J5520
3/4"-16ORB X 10 JIC(M)
8D3212
MALE TIP, 3/4"-16ORB ISO
8D3212
MALE TIP, 3/4"-16ORB ISO
8K9106
CYL PIN
8D9108
ROLL PIN
8T1008
PLASTIC
PLUNGER
REPAIR
KIT
8T1010
BOLT ON
POPPET
ASSY
8T1015
HPC
8T1055
5.5" X 10"
8N4546
1/2" X 546"
8N4228
1/2" X 228"
8N6570
3/4" X 570"
TOP VIEW
DEPTH CONTROL HYDRAULICS 16' & 20' MACHINES
8J6020
3/4"-16ORB X 10 JIC(M) 90° ADP
8T1006
PLUNGER
TO
TRACTOR
TO 5.5"
CYL.
8T2990
CLAMP