Alpine VPA-B222 - Manual (Page 15)

13
-EN
01GB05VPAB222.fm
ALPINE VPA-B222 68-02065Z86-A (EN)
Setting item: CLOCK ADJ
Further setting items: HOUR / MINUTE
Setting content: 1-12 (0-23)* / 0-59
* The setting content differs depending on the selection in "Setting the
Time Display" (page 12).
• Pressing and holding the joystick left or right will change the setting
item continuously.
Setting item: DAYLIGHT TIME
Setting content: OFF / ON
Setting item: BEEP
Setting content: OFF / ON
You can turn the commander vibration ON or OFF during operation.
Setting item: REACTOR
Setting content: OFF / ON
Scroll display is available if CD text, folder name, file name or tag
information is entered.
Setting item: SCROLL AUTO
Setting content: OFF / ON
• Scroll display of the song, artist and album name is enabled when
iPod is connected.
• Short/Long station name, song, artist and album name scrolling are
displayed in HD Radio mode.
System Setup Operation
1
Press and hold MUTE/RTN/SETUP for at least 2
seconds.
The SETUP screen is displayed.
2
Press the joystick up or down to select SYSTEM
SETUP, then press the joystick right.
The SYSTEM SETUP screen is displayed.
Display Example for the SYSTEM SETUP Screen
Setting the Time
HOUR: Adjust the hour.
MINUTE: Adjust the minute.
Setting Daylight Saving Time
ON: Place the Summer Time mode ON. The time advances by
one hour.
OFF: Return to the ordinary time.
Sound (Beep) Guide Function
ON: Activate the Sound Guide mode.
OFF: Deactivate the Sound Guide mode. The sound guide
beep will not be produced when a button on the
commander is pressed.
Turning the Commander Vibration ON or
OFF
OFF: Turns off vibration during operation.
ON: Turns on vibration during operation.
Setting the Scroll
ON: Turns on the AUTO scroll mode. Scroll display is
repeated as long as the mode is turned on.
OFF: Turns off the AUTO scroll mode.
Scroll display is done once as a track is changed.
SYSTEM Setup
To display the System mode screen:
To watch a video source, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow the
procedure below.
1 Brake to bring your vehicle to a complete stop at a
safe location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the System mode operation has been
released. Engaging the parking brake can reactivate the System
mode, as long as the car's ignition has not been turned off. It is
not necessary to repeat the above procedure (1 through 3), of
“To display the System mode screen.”
Each time the ignition is turned OFF, perform the procedure of “To
display the System mode screen.”
The following steps 1 to 5 are common operations to each
“Setting item” of SYSTEM Setup. Refer to each section for
details.
01GB00VPAB222.book Page 13 Friday, January 20, 2006 6:37 PM