Alpine VPA-B222 - Manual (Page 32)

30
-EN
01GB05VPAB222.fm
ALPINE VPA-B222 68-02065Z86-A (EN)
Operating Auxiliary Devices (Optional)
To operate devices connected to the AUX terminals of VPA-B222,
follow the procedure described below.
1
Press SOURCE/POWER.
The source selection screen is displayed.
2
Press the joystick up or down to select the AUX
mode, then press
/ /ENTER.
The external input screen is displayed.
• AUX-1 to AUX are displayed if AUX IN set to ON in “Setting the
AUX mode” (page 15), or the name which is given as the source
name in “Naming External Devices” on page 15 is displayed.
• AUX-3 is displayed when the optional expansion box (VPE-S431) is
connected.
• When the Versatile Link Terminal (KCA-410C) is connected, external
input to KCA-410C is unavailable. However, when IN-INT MUTE is
set to off, the sound of a device connected to the external input of
KCA-410C can be interrupted. (See "Setting the External Device
Interrupt Mode" page 16.)
Auxiliary Device
(Optional)
WARNING
It is dangerous (and illegal in many states) for the
driver to watch the TV/Video while driving the vehicle.
The driver may be distracted from looking ahead and
an accident could occur.
Install the VPA-B222 correctly so that the driver
cannot watch TV/Video unless the vehicle is stopped
and the emergency brake is applied.
If the VPA-B222 is not installed correctly, the driver
will be able to watch the TV/Video while driving the
vehicle and may be distracted from looking ahead and
cause an accident. The driver or other people could
be severely injured.
To activate your auxiliary devices:
To watch a video source, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow the
procedure below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the AUX mode operation has been
released. Engaging the parking brake can reactivate the AUX
mode, as long as the car's ignition has not been turned off. It is
not necessary to repeat the above procedure (1 through 3), of
“To activate your auxiliary devices.”
Each time the ignition is turned OFF, perform the procedure of “To
activate your auxiliary devices.”
• If you try to activate an auxiliary device while driving, the
display will show the warning-PICTURE OFF FOR YOUR
SAFETY.
01GB00VPAB222.book Page 30 Friday, January 20, 2006 6:37 PM