Alpine VPA-B222 - Manual (Page 41)

39
-EN
01GB05VPAB222.fm
ALPINE VPA-B222 68-02065Z86-A (EN)
If MUSIC is selected, the center width can be adjusted with the
following operations.
This function offers the optimum vocal position by adjusting the
center channel position between the center speaker and the L/R
speaker (The adjustments established in “Adjusting the acoustic
image” (page 37) are ineffective while this function is activated).
1 Press the joystick down to select CENTER WIDTH, then
press the joystick left or right to select ON.
2 Press the joystick left or right to adjust the level.
The level can be adjusted between 0 to 7. When the level
increases, the center channel position moves from the
center speaker position to both sides.
The center width control is canceled when set to OFF.
• This adjustment is effective when the setting of the center speaker is
SMALL or LARGE in the speaker setup settings.
• Avoid stopping, pausing, switching the disc, cueing, fast-forwarding
or switching the audio channel of this unit while making this
adjustment. The setting is canceled if the Decode mode is switched.
• This adjustment is ineffective when the speaker is set to CENTER
OFF in “Setting the Speakers” (page 33).
• This function only works with two-channel signals. This operation is
ineffective when 5.1-channel DTS or Dolby Digital signals are input.
• If the setting of REAR FILL is made when REAR MIX is ON, sound is
unchanged in the rear fill setting because REAR MIX is given priority
during 2 channel decoder other than linear PCM.
• For linear PCM signals, the voice is output from the rear speaker
regardless of the REAR FILL and REAR MIX setting.
• Pressing MUTE/RTN/SETUP will return to the previous screen.
Linear PCM Setting
The output when playing discs recorded in linear PCM can be set to 2 or
3 channels.
1
Check that Defeat mode is off (page 10).
2
Press and hold MUTE/RTN/SETUP for at least 2
seconds.
The SETUP screen is displayed.
3
Press the joystick up or down to select AP SETUP,
then press the joystick right.
The AP SETUP screen is displayed.
4
Press the joystick up or down to select PCM
MODE.
5
Press the joystick left or right to select 2CH or
3CH.
• This adjustment is ineffective when the speaker is set to CENTER
OFF in “Setting the Speakers” (page 33).
If the Alpine touch panel compatible monitor is connected to this unit,
touch operation can be performed by directly touching the monitor.
Refer to each section for details.
• Operation may differ depending on the connected device. Refer to
owner’s manual of the connected device.
Basic operation
The following example for the radio screen and source selection screen
explains for basic operation.
<RTN>
Returns to the main source screen.
/
Scrolls the list.
Selects the item.
SOURCE (page 7)
The source selection screen is displayed.
NAV. (page 28)
The Navigation screen is displayed.
CONTROL
Displays the function screen on the connected touch panel
compatible with the monitor.
VOL. / (page 7)
Adjusts the volume.
MUTE (page 7)
Turns mute on and off.
FUNC.
Displays the FUNCTION screen of each source.
2CH: 2ch output (L/R)
3CH: 3ch output (L/R/CENTER)
Soft button
operation
01GB00VPAB222.book Page 39 Friday, January 20, 2006 6:37 PM