Alpine VPA-B222 - Manual (Page 26)

24
-EN
01GB05VPAB222.fm
ALPINE VPA-B222 68-02065Z86-A (EN)
SIRIUS Radio:
* 1 Channel name, category, song name, etc., are displayed in one
screen.
* 2 XM mode only: The information display appears when ON is set in
“Setting the Auxiliary Data Field Display” (page 17).
Checking the SAT Radio ID Number
A unique Radio ID number is required to subscribe to SAT Radio
programming. Each third party XM or SIRIUS radio comes with this
number.
XM Radio:
This number is an 8 character alphanumeric number. It is printed on a
label found on the SAT Receiver.
SIRIUS Radio:
This number is a 12 character alphanumeric number. It is printed on a
label found on the SAT Receiver.
It can also be displayed on the screen of the VPA-B222 in the following
way.
1
Press / /ENTER to select the channel number
turing mode.
2
While receiving a SAT Radio band, press or
to select channel "0" for XM, or to select
channel "255" for SIRIUS.
3
The unit displays the ID number.
4
To cancel the ID number display, change the
channel.
• You cannot use “O,” “S,” “ I,” or “F” for the ID Number. (XM radio
Receiver only)
• You can check the ID number printed on a label on your third party,
SAT Radio Receiver package.
Storing Channel Presets
1
Press and hold /MENU/FUNC. for at least 2
seconds after selecting a desired band.
The FUNCTION screen is displayed.
2
Press the joystick up or down to select PRESET
MEMORY, then press the joystick right.
3
Press the joystick up or down to select any one of
the preset numbers PRESET1 through PRESET6,
then press
/ /ENTER.
The selected station is stored.
4
Repeat the procedure to store up to 5 other channels
onto the same band.
To use this procedure for other bands, simply select the
desired band and repeat the procedure.
A total of 18 channels can be stored in the preset memory
(6 channels for each band; XM-1, XM-2 and XM-3 or
SIRIUS-1, SIRIUS-2 and SIRIUS-3).
• If you store a channel in a preset already being used, the current
channel will be replaced with the new one.
Receiving Stored Channels
1
Press and hold for at least 2 seconds repeatedly
until the desired band is displayed.
2
Press and hold /MENU/FUNC. for at least 2
seconds.
The FUNCTION screen is displayed.
3
Press the joystick up or down to select PRESET
CALL, then press the joystick right.
4
Press the joystick up or down to select any one of
the preset numbers PRESET1 through PRESET6,
then press
/ /ENTER.
The selected station is received.
• During reception, you can change the station by pressing or .
01GB00VPAB222.book Page 24 Friday, January 20, 2006 6:37 PM