Alpine VPA-B222 - Manual (Page 9)

7
-EN
01GB05VPAB222.fm
ALPINE VPA-B222 68-02065Z86-A (EN)
Switching a Source
1
Press SOURCE/POWER.
The source selection screen is displayed.
Screen example
Displays source modes that can be selected
(The kind of source modes that are displayed varies
depending on connection and setting)
2
Press the joystick up or down to select the desired
source, then press
/ /ENTER.
The selected main source screen is displayed.
• In the source selection screen mode, press MUTE/RTN/SETUP to
return to the previous screen.
Adjusting the Volume
Turn the flipper switch clockwise or counterclockwise
to adjust the volume.
Clockwise: Volume up
Counterclockwise: Volume down
Volume: 0 - 35
Lowering Volume Quickly
Activating this function will instantly lower the volume level.
Press MUTE/RTN/SETUP to activate the MUTE mode.
The audio level decreases.
During mute, the volume level indicator will blink.
Pressing MUTE/RTN/SETUP again brings the audio back to its
previous level.
This unit cannot receive HD Radio™ signals (digital terrestrial radio).
In order to activate the digital radio functions described below, an
optional HD Radio Tuner module must be connected through the
Ai-NET bus.
Band display
Preset number display
Frequency display
Listening to Radio
1
Press SOURCE/POWER.
The source selection screen is displayed.
2
Press the joystick up or down to select RADIO, then
press
/ /ENTER.
3
Press and hold for at least 2 seconds repeatedly
until the desired radio band is displayed.
FM-1 FM-2 AM FM-1
4
Press / /ENTER to select the tuning mode.
• The initial mode is Distance mode.
DX SEEK (Distance mode):
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
SEEK (Local mode):
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
OFF (Manual mode):
The frequency is manually tuned in steps (Manual tuning).
Radio
DX SEEK SEEK (OFF) DX SEEK
Joystick
01GB00VPAB222.book Page 7 Friday, January 20, 2006 6:37 PM