AGFA TM 14ADV - Manual (Page 132)

User’s Manual 6-13
SOLVING
PROBLEMS
Error Indications
Problem Solutions
Pages have toner stains or If this problem occurs after a paper
smudging jam, print several pages.
Clean the paper path.
Clean the paper guide before the
corona wire.
Clean the corona wire.
Replace the cleaner pad.
If the fuser unit is damaged, contact
your dealer.
Toner insufficiently adheres
to or easily comes off paper
when you are printing thick
or special paper.
Vertical lines appear in solid
black printing, stains appear
in the back of a page, or
paper is wrinkled or curled.
Turn the thick paper mode on
using the control panel .
Check if the thick paper mode is
on by using the control panel; if
the mode is on, turn it off.
Errors refer to a problem or condition which requires you to take
action. The printer shows errors by using the ERROR indicator and
the message display of the control panel. The following table lists the
error indications, explains causes, and suggests solutions.
Message Causes and solutions
BD CYCLE ERROR Cause: Malfunction in the laser unit
Solution: If the error recurs, consult
your dealer for service.
COMM.ERROR Cause: Communication error
Solution: Press the
button and
select the correct settings of the serial
interface using the control panel setup
mode.
Error Indications
08 Chapter 6 07.08.1997, 11:41 Uhr 13