AGFA TM 14ADV - Manual (Page 96)

User’s Manual 4-11
ENHANCING &
CUSTOMIZING
Adding Paper Sources
To install the paper feeder, follow these steps:
1. Turn off the printer and
disconnect the power cord.
2. Make sure the lock lever is
set to the open side. Push
down the lever at the left
side of the paper feeder.
3. Mount the printer on the
paper feeder. Grip the
bottom left and right sides
of the printer to lift the
printer and place it on the
paper feeder. When placing
the printer on the paper
feeder, be sure you insert
the two guide pins of the
paper feeder into the two
positioning holes at the
bottom of the printer.
4. Set the lock lever to the
lock side. Pull up the lever.
Notice:
Be careful not to drop the printer on the paper feeder.
Do not touch any connector contacts to avoid possible electrostatic
damage to the printer and paper feeder.
For paper loading, refer to Loading Paper and Installing the Paper
Tray in Chapter 1. For paper sizes and types as well as tips on
handling paper, refer to Handing Paper in Chapter 3.
Hold here (opposite
side as well)
Guide pins
Lock
lever
☞
Paper
feeder
06 Chapter 4 07.08.1997, 11:41 Uhr 11