AGFA TM 14ADV User Manual
Page 75
3-22
User’s Manual
Handling Paper
Although this printer can print on any sheet within the limits stated
above, printing area and margin calculations are based on several
paper sizes as shown in the table below. Use the control panel to
change the supported paper size.
Paper size (logical)
Dimensions
A4
210
×
297 mm
A5
148
×
210 mm
Letter
8.5
×
11 inches
Legal
8.5
×
14 inches
Executive
7.25
×
10.5 inches
Envelope COM-10
4 1/8
×
9.5 inches
Envelope Monarch
3 7/8
×
7.5 inches
Envelope C5
162
×
229 mm
Envelope DL
110
×
220 mm
Envelope B5
176
×
250 mm
When the PCL emulation is used and if the physical paper size (tray
size or MFF paper size) is different from the logical paper size (value
specified by setup menu of paper size), a paper mismatch error
occurs.
General Tips
Observe the following tips when handling print media.
• Do not use paper that is wrinkled or curled.
• Do not use paper with staples or metal parts.
• When printing both sides of sheets, we recommend you to use an
optional duplex unit. If your printer has no duplex unit, use the
manual feed slot and remove curls after first printing. Use paper in
105 g/m
2
(28 pound) weight. Paper thinner than this weight may
be wrinkled thus causing decrease in print quality.
• Two-sided printing is not allowed for transparencies, envelopes,
and labels even if your printer has the duplex unit.
05 Chapter 3
07.08.1997, 11:40 Uhr
22