AGFA TM 14ADV - Manual (Page 133)

6-14 User’s Manual
Message Causes and solutions
COVER OPEN 1 Cause: Incomplete closing of upper door
Solution: Close the upper door.
Note: See caution following in this table.
COVER OPEN 2 Cause: Incomplete locking of paper guide
inside the rear stacker
Solution: Lock the paper guide.
Note: See caution following in this table.
COVER OPEN 3 Cause: Incomplete closing of rear unit of
the optional duplex unit.
Solution: Close the rear unit of the
duplex unit.
FUSER FAILURE Cause: Malfunction in the fuser unit
Solution: If the error recurs, consult your
dealer for service.
INVALID SIMM Cause: Incorrect SIMM card (optional
emulation or font) installed
Solution: Press the
button.
JOB TIMEOUT Cause: FPS job timeout (This error
occurs when the FPS card is installed.)
Solution: Press the
button.
LOAD MFF size Cause: Paper mismatch occurred.
LOAD TRAYn size Solution: Set the specified tray to the
correct paper size specified.
MANUAL TIMEOUT Cause: Paper was not inserted into the
manual feed slot in the prescribed time.
(This error occurs when the FPS card is
installed.)
Solution: Press the
button.
MEMORY OVER FLOW Cause: Memory overflow error
Solution: Press the
button.
MEMORY SHORTAGE Cause: Insufficient memory
Solution: Add RAM board.
MFF NOT INSTALL Cause: No MFF installed
Solution: Install the MFF.
Error Indications
08 Chapter 6 07.08.1997, 11:41 Uhr 14