AGFA TM 14ADV - Manual (Page 50)

User’s Manual 2-5
PRINTER
SOFTWARE
Feature Default Other options or range
Personality (*8) Auto PCL, PS
Jam recovery (*9) Off On
PS error report (*9) Off On
Auto continue Off On
Acknowledge (*10) Inside Outside
I/O timeout (*11) 15 15 to 300 seconds
Parallel interface LPT1 LPT2, LPT3
Serial interface COM1 COM2
Top offset (*12) 0.0 -25.0 to +25.0 mm
(0.1 mm steps)
Left offset (*12) 0.0 -25.0 to +25.0 mm
(0.1 mm steps)
Remote Setup Utility Program, PPMENU
*1 Letter for USA and A4 for Europe
*2 This is for letter and portrait. It automatically changes depending on
paper size and page orientation.
*3 Tray 2 is displayed when the optional paper feeder is installed. MFF
is displayed when the optional multi-function feeder (MFF) is
installed. AUTO (Tray 1 not used), AUTO (Tray 2 not used),
AUTO (MFF not used), and AUTO (All Select) are displayed
collectively as AUTO when above options are not installed.
*4 Duplex mode and binding are valid when the duplex unit is installed.
*5 Font source is subordinate to the typeface and cannot be selected.
*6 The screen format changes depending on font information (except
for resident fonts) and compatible mode setting.
*7 FEIT is the acronym for Fujitsu Enhanced Image Technology that
makes the contours of objects appear smoother than with this
printer’s resolution normally possible.
*8 The screen format changes depending on personality setting.
*9 Jam recovery and PS error report are valid when the optional FPS
card (PostScript level 2 compatible emulation card) is installed.
*10 This is for the Centronics parallel interface.
*11 This is essential for sharing the printer among multiple computers.
*12 Effective when PCL is selected for the personality. These values are
used as defaults of top and left offset specifications in PCL mode.
04 Chapter 2 07.08.1997, 11:40 Uhr 5