AGFA TM 14ADV - Manual (Page 89)

4-4 User’s Manual
Installing an Interface Expansion Board
Installing an
Interface
Expansion Board
☞
Ethernet interface board Serial interface board LocalTalk interface board
The printer’s standard interface is parallel. The available optional
interfaces are serial, LocalTalk, and Ethernet. If your computer
cannot use a parallel port for your printer or the location of your
printer is distant from the computer, you can use the serial port,
LocalTalk port, or Ethernet port of the computer to connect your
printer. Fujitsu offers the optional serial interface (RS-232C/422A)
board, LocalTalk board, and Ethernet board C for these purposes.
Notice:
When sharing the printer among multiple computers, setting the I/O
time-out short may cause a printing problem.
Installing an Interface Board
1. To install an interface
board, first make sure the
printer is turned off.
Remove the interface board
slot cover from the back
right of the printer.
2. Hold the board with the
parts mounting side left.
Slide the board into the
empty interface slot using
the guides, and push it until
it stops. Secure the board by
the two screws supplied
with it.
Remove
the cover
Secure
screws
(Example: serial interface)
06 Chapter 4 07.08.1997, 11:41 Uhr 4