ATEN CL-1208 - Manual (Page 15)

1 Handle Pull to slide the KVM module out; push to slide the module
in (see item 13 in this table).
2 LCD Display After sliding the KVM module out, flip up the cover to
access the LCD monitor.
3 LCD Controls The LCD On/Off switch is located here, as well as buttons
to control the position and picture settings of the LCD
display. See p. 19, for details.
4 Port Switches Press a switch to bring the KVM focus to the computer
attached to its corresponding port. See p. 21 for details.
5 Port LEDs Two Port LEDs are built into the Port Switches. The one on
the left is the On Line LED; the one on the right is the
Selected Port LED:
w An On Line LED lights ORANGE to indicate that the
computer attached to its corresponding port is up and
running.
w A Selected LED lights GREEN to indicate that the
computer attached to its corresponding port is the one
that has the KVM focus. The LED is steady under normal
conditions, but flashes when its port is accessed under
Auto Scan Mode (see p. 38).
6 Keyboard
7 Touchpad
8 Power LED Lights BLUE to indicate that the unit is receiving power.
9 Rack Mounting
Tabs The rack mounting tabs located at each corner of the unit
secure the chassis to a system rack. Refer to the Appendix
(p. 60), for rack mounting details.
10 Lock LEDs The Num Lock, Caps Lock, Scroll Lock LEDs are located here.
11 Reset Switch Located to the right of the Lock LEDs. Press this recessed
switch in with a thin object to perform a system reset.
12 Firmware
Upgrade
Section w Firmware Upgrade Port: The Firmware Upgrade Cable
that transfers the firmware upgrade data from the
administrator’s computer to the CL-1208 / CL-1216 plugs
into this RJ-11 connector.
w Firmware Upgrade Switch: During normal operation
this switch should be in the NORMAL position. (See p. 49
for firmware upgrading details.)
13 Slide Release In order to bring the console out, you must first release it by
sliding these tabs to the inside. See p. 17 for details on
sliding the console in and out.
2005-04-26
Introduction
7