ATEN CL-1208 - Manual (Page 39)

(F3 SET: continued)
Setting Function
PORT ID
DISPLAY
MODE Selects how the Port ID is displayed: the Port Number alone
(PORT NUMBER); the Port Name alone (PORT NAME); or the
Port Number plus the Port Name (PORT NUMBER + PORT
NAME). The default is PORT NUMBER + PORT NAME).
SCAN
DURATION Determines how long the focus dwells on each port as it cycles
through the selected ports in Auto Scan Mode (see F7 SCAN, p.
38). Key in a value from 1 - 255 seconds, then press [Enter].
Default is 5 seconds; a setting of 0 disables the Scan function.
SCAN/SKIP
MODE Selects which computers will be accessed under Skip Mode (see
F5 SKP, p. 36), and Auto Scan Mode (see F7 SCAN, p. 38).
Choices are:
ALL - All the Ports which have been set Accessible (see SET
ACCESSIBLE PORTS, p. 34);
QUICK VIEW - Only those Ports which have been set Accessible
and have been selected as Quick View Ports (see SET QUICK
VIEW PORTS, p. 34);
POWERED ON - Only those Ports which have been set
Accessible and are Powered On;
QUICK VIEW + POWERED ON - Only those Ports which have
been set Accessible and have been selected as Quick View Ports
and are Powered On. The default is ALL.
SCREEN
BLANKER If there is no input from the console for the amount of time set
with this function, the screen is blanked. Key in a value from
1 - 30 minutes, then press [Enter]. A setting of 0 disables this
function. The default is 0 (disabled).
HOTKEY
COMMAND
MODE Enables / Disables the Hotkey Command function in case a
conflict with programs running on the computers occurs.
2005-04-26
OSD Operation
31