ATEN CL-1208 - Manual (Page 42)

(F4 ADM: continued)
Setting Function
SET QUICK
VIEW PORTS This function lets the Administrator select which Ports to include
as Quick View ports.
w To select/deselect a port as a Quick View Port, use the
Navigation Keys to move the highlight bar to it, then
press the [Spacebar].
w When a port has been selected as a Quick View Port, an
arrowhead displays in the QV column of the LIST on the Main
Screen to indicate so. When a port is deselected, the
arrowhead disappears.
w If one of the Quick View options is chosen for the LIST view
(see F2 LIST, p. 29), only a Port that has been selected here
will display on the List.
w If one of the Quick View options is chosen for Auto Scanning
(see SCAN/SKIP MODE, p. 31), only a Port that has been
selected here will be Auto Scanned.
The default is for no ports to be selected.
SET
ACCESSIBLE
PORTS This function allows the Administrator to define User access to the
computers on the installation on a Port-by-Port basis.
For each User, select the target Port; then press the [Spacebar] to
cycle through the choices: F (Full access), V (View only), or blank.
Repeat until all access rights have been set, then press [Enter].
The default is F for all users on all ports.
Note: A blank setting means that no access rights are granted.
The port will not show up on the User’s LIST on the Main Screen.
(Table continues on next page)
2005-04-26
CL-1208 / CL-1216 User Manual
34