ATEN CL-1208 - Manual (Page 51)

Auto Scanning
Auto Scan automatically switches among all the active CPU Ports that are
accessible to the currently logged on User at regular intervals, allowing
automatic monitoring of computer activity. (See Scan/Skip Mode of the OSD
F3 SET function, p. 31 for information regarding accessible ports.)
Setting the Scan Interval:
The amount of time Auto Scan dwells on each port is set with the Scan
Duration setting of the OSD F3 SET function (see p. 31). You can change
the scan interval before activating Hotkey Auto Scanning, if you wish, with
the following Hotkey combination:
1. Invoke HKM (see p. 41).
2. Key in [T] [n]
Where [T] is the letter T, and [n] is a number from 1-255 that represents the
number of seconds the system dwells on a port before going on to the next.
The letter T and the numbers display on the Command Line as you key
them in. If you make a mistake, use [Backspace] to erase the wrong
number.
3. Press [Enter]
After you press [Enter], you automatically exit Hotkey Mode, and are
ready to invoke Auto Scanning.
2005-04-26
Hotkey Operation
43