Sony DHC-MD595 - Manual (Page 22)

22
Last programmed
track number
Cancel
Program Play Press x, then press PLAY MODE
repeatedly until “PROGRAM” and
“SHUFFLE” disappear.
Add a track to
the program (in
stop mode) Do steps 3 and 4.
Total playing time
of the program
To check the program order
Press . or > repeatedly during Program
Play.
To Do this
Erase the last
programmed
track
Last programmed
track number
Programming MD tracks
(continued)
Press CLEAR in stop mode. Each
time you press the button, the last
programmed track is erased.
To select the desired track using
the number buttons
Press number buttons instead of performing steps
3 to 5.
To enter track numbers 10 or over, press >10
(press twice to enter 100 or over) and the track
number. To enter 0, use the 10/0 button.
Tips
• The program you made remains after Program Play
finishes. To play the same program again, press MD
N.
• “Step Full!” appears when you try to program 26 or
more tracks (steps).
• “---.--” appears when the total MD program time
exceeds 1,000 minutes.
4
Press ENTER/YES.
The track is programmed.
“Step” appears, followed by the number of
the track in the programmed sequence. The
number of the last programmed track
appears, followed by the total playing time of
the program. If you have made a mistake,
you can clear the last programmed track from
the program by pressing CLEAR.
Total playing time
5
To program additional tracks, repeat
steps 3 and 4.
6
Press MD N.
All the tracks play in the order you selected.
To check the total number of
programmed tracks
Press TIME in stop mode. The total number of
programmed steps appears, followed by the last
programmed track number and the total playing
time of the program.