Sony DHC-MD595 - Manual (Page 8)

8
1
Press TUNER/BAND to select “FM” or
“AM”.
2
Press TUNING MODE repeatedly until
“AUTO” appears.
3
Press TUNING + or –.
The frequency indication changes and the
scanning stops when the system tunes in a
station. “TUNED” and “STEREO” (for a
stereo program) appear.
4
Press MENU/NO on the remote.
5
Press – or + on the remote repeatedly
until “Memory?” appears, then press
ENTER/YES on the remote.
The preset number starts flashing. Perform
steps 6 and 7 while the preset number is
flashing.
6
Press – or + on the remote repeatedly to
select the desired preset number.
7
Press ENTER/YES.
“Complete!” appears, and then the station is
stored.
8
Repeat steps 1 to 7 to preset other
stations.
To stop scanning
Press TUNING MODE on the remote.
To tune in a station with a weak
signal
Press TUNING MODE repeatedly until
“MANUAL” appears in step 2, then press
TUNING + or – repeatedly to tune in the station
manually.
To change the preset number
Start over from step 1.
To change the AM tuning interval
(except for the European model)
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM tuning
interval, tune in any AM station first, then turn off
the system. While holding down the FUNCTION,
turn the system back on. When you change the
interval, all the AM preset stations are erased. To
reset the interval, repeat the same procedure.
Tips
• The preset stations are retained for about a day even
if you disconnect the power cord or if a power
failure occurs.
• You can label the preset stations (see page 53).
• When an FM program has static noise,
press STEREO/MONO until “MONO” appears.
There will be no stereo effect, but the reception will
improve. Press the button again to restore the stereo
effect.
Step 3: Presetting radio
stations (continued)