Agilent Technologies EN 61000-3-2 - Manual (Page 73)

73
A
Specifications
Supported or Referenced EN 61000-3-2 and EN 60555 Part 2 Standards
IEC 555-2 EN 61000-3-2
EN 60555 Part 2 IEC 1000-3-2
IEC 1000-4-7
Supported or Referenced EN 61000-3-3 Standards
IEC 725 EN 61000-3-3
IEC 868 IEC 1000-3-3
IEC 868 Amendment 1
PC Requirements
Minimum: 486DX 33 Mhz
512 Kbytes of conventional memory
8 Mbytes of RAM
210 Mbyte IDE Hard Disk
1
(4 Mbytes required for installation)
Windows 3.1, or Windows for Workgroups 3.11
Networking disabled
Recommended: 486DX4 100 Mhz or Pentium
512 Kbytes of conventional memory
16 Mbytes of RAM
1.2 Gbyte IDE PCI Hard Disk
1
(4 Mbytes required for installation)
Windows 95 workstation
2
, or Windows NT 4.0 workstation
Networking disabled
1 Accommodates data storage for the maximum possible test length of 7 days.
2
For Windows 95, plug and play I/O cards are recommended.
Supported GPIB Interfaces
Agilent 82335B, 82340B, 82341C/D, 82350A GPIB Interface
National Instruments AT-GPIB/TNT, AT-GPIB/TNT PnP (Windows 95 only), AT-GPIB/TNT PCMCIA
Supported Equipment
Agilent 6812B AC Power Source/Analyzer (300 V, 6.5 Arms max., single-phase)
Agilent 6813B AC Power Source/Analyzer (300 V, 13 Arms max., single-phase)
Agilent 6841A Harmonic/Flicker Test System (300 V, 6.5 Arms max., single-phase)
Agilent 6842A Harmonic/Flicker Test System (300 V, 13 Arms max., single-phase)
Agilent 6843A Harmonic/Flicker Test System (300 V, 16 Arms max., single-phase)