Acer Altos R500 - Manual (Page 100)

5 Setup utility 90
Onboard LAN 1
Onboard LAN 2
Onboard LAN 3
Onboard LAN 4
When you set the PCI IRQ Setting parame-
ter to Auto, this parameter specifies the
auto-assigned interrupt for the onboard
LAN controlers installed in your system.
When you set the PCI IRQ Setting parame-
ter to Manual, you need to specify the
interrupt that you want to assign for the
onboard LAN controllers installed in your
system.
User input
Onboard SCSI Allows you to manually assign the inter-
rupt for the onboard SCSI when the PCI
IRQ Setting parameter is set to Manual.
This parameter is grayed and not user-con-
figurable when the PCI IRQ Setting is set to
Auto. User input
Onboard RAID User input
USB Host
Controller Allows you to manually assign the
interrupt for the USB host controller when
the PCI IRQ Setting parameter is set to
Manual. This parameter is grayed and not
user-configurable when the PCI IRQ Setting
is set to Auto. Disabled
Enabled
PCI IRQ Sharing Setting this parameter to Yes allows you to
assign the same IRQ to two different
devices. To disable the feature, select No.
Note: If there are no IRQs available to
assign for the remaining device function, it
is recommended that you enable this
parameter.
Yes
No
Parameter Description Option
aa r500.book Page 90 Thursday, September 20, 2001 11:06 AM