Installing the redhat linux server agent – Acer Altos R500 User Manual
Page 116
Appendix A: ASM Pro quick installation guide
106
10 Enter a password and click OK. A password is required when using
the ASM Pro Console to remotely change or set any value for the
NT Agent. If the password is disabled, there is no security
protection for the agent when the ASM Pro Console tries to
change or set these values.
11 Enter the IP address of the ASM Pro Console system, then click
ADD to add trap destinations. Click OK to end the asmcfg utility.
This IP address tells the Agent where to report (trap).
12 Click Yes to save your changes. The View Readme File dialog box
appears.
13 Click Yes to view, No to continue.
14 Click Finish to exit setup.
Installing the RedHat Linux Server Agent
Follow these steps to install the Red Hat Linux Agent:
1
Insert the Management CD into your system’s CD-ROM drive.
2
Login Linux server as a super user.
3
In shell prompt, type the following to mount CD-ROM:
mount /dev/hdX /mnt/cdrom.
4
In shell prompt, type the following to change to the new
directory:
cd /mnt/cdrom/App/ASM/Linux.
5
In shell prompt, type the following to install ASM Pro SNMP
agent:
/bin/rpm -i asmpro-agent-4.5-4.rh62.i386.rpm.
6
In shell prompt, type the following to configure "SNMP_Config"
to receive trap:
/usr/local/share/asm/asmcfg.
7
In shell prompt, type the following to start ASM Pro agent:
/usr/local/share/asm/asm-snmpd start.
8
In shell prompt, type the following to stop ASM Pro agent if
necessary:
/usr/local/share/asm/asm-snmpd stop.
aa r500.book Page 106 Thursday, September 20, 2001 11:06 AM