Acer Altos R500 - Manual (Page 46)

4 Upgrading your system 36
Warning! Failure to properly turn off the computer before
you start installing components may cause serious
damage.
Do not attempt the procedures described in the following
sections unless you are a qualified service technician.
Post-installation instructions
Observe the following after installing a computer component:
1 See to it that all components are installed according to the
described step-by-step instructions.
2 Replace any expansion board(s) or peripheral(s) that you have
previously removed.
3 Connect the necessary cables.
4 Replace the system cover.
5 Turn on the system.
aa r500.book Page 36 Thursday, September 20, 2001 11:06 AM