Acer Altos R500 User Manual
Page 133
Advertising
123
Note:
Look for an imprint that says “front” or “rear” on the
mounting bracket. Install the mounting bracket on the
appropriate side; otherwise, it will not fit correctly into the rack.
g
Secure it with three M4xL8 screws with nut and washer as
shown below. Slide and adjust the inner piece of the
mounting rail to gain access to the screw holes. The position
of the mounting bracket on this end is fixed.
h
Extend the inner sliding piece of the mounting rail until you
can see the screw holes on the other end. Attach the
mounting bracket to the rear end and secure it with two
M4xL8 screws. The mounting rail on this end is adjustable.
aa r500.book Page 123 Thursday, September 20, 2001 11:06 AM
Advertising