Acer Altos R500 - Manual (Page 95)

85
Hidden
Partition If you want the hidden partition to become
accessible, set this parameter to Enabled.
When enabled, the server boots to the hid-
den partition. Disabled
Enabled
Communica-
tion Protocol This parameter specifies the parity, stop
bits, and data length for the COM port to
use for RDM connection. This is fixed at N
(none), 8, 1 setting and is non-configurable. N
8
1
COM Port Baud
Rate This parameter lets you set the transfer rate
of the COM port for RDM connection. The
parameter setting depends on your modem
specification; therefore, before you change
the setting of this parameter, check the
documentation that came with your
modem. 9600
57600
Detect Tone When enabled, RDM first checks for the
existence of a telephone tone before it dials
out.
When disabled, RDM proceeds with the
dialing process without checking for a
telephone tone. Enabled
Disabled
Remote
Console Phone
No. This parameter allows you to set the phone
number of the RDM manager station that
the RDM module must dial once RDM is
activated and the Remote Console is
enabled. To set, simply highlight the
parameter and enter the Remote Console
phone number.
If the remote console phone number is
using an (X) line, then you must enter six
commas (,) after the phone number and
before the extension number, if any. When
entering the extension number, we recom-
mend that you insert a comma after each
number. The commas specify delay.
If this parameter is left blank, the Remote
Console calling function is disregarded.
User input
Parameter Description Option
aa r500.book Page 85 Thursday, September 20, 2001 11:06 AM