Pulsafeeder Eclipse Model 75 - Manual (Page 21)

15
9. Insert a bearing (item 10) into the center housing (item 14) and slide to the bottom of the housing. Bearings are
symmetrical and orientation does not matter.
10. Install the housing liner (item 11) and slide until it seats against the first bearing. Install the idler gear (item 12)
into the top hole in bearing until the gear seats against the first bearing.
11. Install the drive gear (item 13), splined-end first, into the assembly until it bottoms out against the bearing. The
shaft may have to be rotated slightly to properly fit the splined-end into the drive magnet and gear to the idler gear
assembly.
12. Insert the second bearing (item 10) into the housing bore until it rests against the housing liner. Bearings are
symmetrical and orientation does not matter.
Figure 13
13. Install the spacer o-ring (item 9) into front cover as shown. Some o-ring lubricant may help keep the o-rings in
place during assembly.
Figure 14