Pulsafeeder Eclipse Model 75 - Manual (Page 40)

34
4. Install o-ring (item 15) into the back side of the center housing (item 14) as shown. Some o-ring lubricant
may help keep the o-rings in place during assembly. Be sure the o-ring is fully seated into housing groove.
Figure 42
5. Place the center housing (item 14) onto the motor spool, aligning the port connections with the pump
baseplate as shown. Place the two retaining plates (item 35) onto the center housing and secure with eight
bolts and washers (items 16, 17). Tighten bolts to the torque specified in Section 12. Always tighten fasteners
in a progressive “crisscross” pattern.
6. Insert a bearing (item 10) into center housing (item 14) and slide to bottom of bore. Bearings are symmetrical
and orientation does not matter. Install the housing liner (item 11) and slide until it seats against the first
bearing. Install idler gear (item 12) into the top hole in the bearing until the gear seats against the first
bearing.
7. Install the drive gear (item 13), splined-end first, into the assembly until it bottoms out against the bearing.
The shaft may have to be rotated slightly to properly fit the splined-end into the drive magnet and mesh gear
teeth with the idler gear.