Pulsafeeder Eclipse Model 75 - Manual (Page 19)

13
6.3 Assembly
1. Place motor spool (item 20) flat on work surface. Align “molded-in” flats on the spool adapter plate (item 18)
with any two of the motor mounting bolt holes on the motor spool as shown.
2. Set in place and install eight mounting bolts and washers (items 16, 17). Tighten these bolts to the torque
specified in Section 12. Always tighten fasteners in a progressive “crisscross” pattern.
3. Install the containment can (item 19) into the spool adapter plate until it is properly seated into the assembly.
4. Install the driven magnet assembly (item 21) into the containment can. The driven magnet is symmetrical and can
be inserted with either end facing out (orientation does not matter).
Figure 10
5. Inspect all o-rings to be sure there is no damage such as pinching prior to assembly.