Setting up ndmp, Procedure, Assign ndmp names to devices – ATTO Technology 2500C User Manual
Page 21
12
Configuration: NDMP
Setting up NDMP
The ATTO iPBridge should first be configured for
the network using the RS-232 port to establish the
correct IP address, subnet mask, gateway and
iPBridge names. Authentication can require the
use of a client name-password pair, along with
configuration of the security level (MD5, Text, or
None) used for authentication. The iPBridge 2500
does not validate the client-name, and a single
password is used for all password fields within the
iPBridge 2500.
The NDMP port number is user-configurable,
with the industry standard (10000) as the default.
NDMP device mapping links a SCSI btl (bus,
target, LUN) to an ASCII device name. If you do
not use the default mapping, you must map
devices before using NDMP.
Procedure
1
Configure IP addresses, subnet masks, IP
gateways and iPBridge names if necessary
(refer to
on page 10) for
each port. Defaults are IP address 10.0.0.1;
subnet mask 255.255.0.0
2
Configure mapping for SCSI devices (refer to
3
Set NDMP version number and NDMP port
numbers for each data port you wish to use and
the NDMP authorization type for all ports. The
default NDMP port number is 10000.
4
Enter the NDMP Max Version and Port
Number in the Ethernet Port Configuration
Page
5
Click submit
6
Enter the NDMP Authorization Type in the
Bridge Configuration page
7
Click Submit
8
Click Restart on the Restart Firmware page.
9
Configure third party software.
Assign NDMP names to devices
1
From the ExpressNAV main menu, click on the
Mapping menu item on the left side of the
screen.
2
Type the NDMP names you want in the boxes
at the right.
3
Drag the boxes to the ports you want.
4
Click Submit
5
Go to the Restart Firmware page and click
Restart.