ATTO Technology 2500C - Manual (Page 52)

43
ATTO Technology Inc. iPBridge Installation and Operation Manual
7.1.4 Diagnostic commands
ATTO iPBridge diagnostic commands help validate iPBridge operation and diagnose or isolate
iPBridge faults. Event logging is a mechanism for on-site observation of internal iPBridge behavior
such as tracing SCSI commands received over the GbE from the host and return of data and status to
the host.
BridgeModel
Reports model information about a specific iPBridge
Get syntax: get BridgeModel
BridgeName
Specifies name used to identify individual iPBridge units.
May be up to a maximum of eight characters. It is not the
World Wide Name (WWN).
Set syntax: set BridgeName [value]
Takes effect immediately
Get syntax: get BridgeName
ClearEventLog
Clears the contents of the event log. No events are
recorded until the command has been completed.
Immediate command: ClearEventLog
ClearTraceLog
Clears the contents of the trace log. No events are
recorded until the command has been completed.
Immediate command: ClearTraceLog
DisplayEventLog
Displays the most recent page of event log entries. Typing
a +, - or = causes the next, previous or same page of
event log entries to be displayed. No events are recorded
until the command has been completed. Type <escape>
to disable the command, begin new log entries, and return
to CLI.
Immediate command: DisplayEventLog < + | - | =| q>
DisplayEventLogFilter
Filters the display of data for specific iPBridge
subsystems when in DisplayEventLog mode. If enabled
for a particular subsystem and level, that subsystem and
level is masked when the command DisplayEventLog is
issued.
Subsystem entries: ................ Log level entries:
....... SCSI ................................. INFO
....... ENET ................................ WARN
....... GEN .................................. CRIT
....... NVRAM .............................. FAIL
....... PERF ................................ ALL
....... ECC
....... ALL
....... HTTP
....... iSCSI
....... NDMP
Default: disabled
Set syntax: set DisplayEventLogFilter [subsystem] [level]
[enabled|disabled]
Get syntax: get DisplayEventLogFilter [subsystem] [level]
DisplayTraceLog
Displays the most recent page of trace log entries. Typing
a +, - or = causes the next, previous or same page of trace
log entries to be displayed. No events are recorded until
the command has been completed. Type <escape> to
disable the command, begin new log entries, and return
to CLI.
Immediate command: DisplayTraceLog < + | - | = | q>
DisplayTraceLogFilter
Filters the display of data for specific iPBridge
subsystems when in DisplayTraceLog mode. If enabled
for a particular iPBridge port, that port is masked when
the command DisplayTraceLog is issued.
Default: disabled
Set syntax: set DisplayTraceLogFilter [ndmp| scsi | all]
[dp |sb | all] [enabled | disabled]
Get syntax: get DisplayTraceLogFilter [ndmp | scsi | all ]
[dp |sb | all ]