ATTO Technology 2500C - Manual (Page 53)

44
CLI
DumpEventLog
Dumps the contents of the entire event log to an RS-232
or telnet session (over Ethernet) without impact on the
log itself (the log is not cleared). No events are recorded
until the command has been completed.
Immediate command: DumpEventLog
DumpTraceLog
Dumps the contents of the entire trace log to an RS-232
or telnet session (over Ethernet) without impact on the
log itself (the log is not cleared). No events are recorded
until the command has been completed.
Immediate command: DumpTraceLog
EventLog
When enabled, records various system events to the event
log.
Default: enabled
Set syntax: set EventLog [enabled|disabled]
Requires a SaveConfiguration command
Get syntax: get EventLog
EventLogFilter
Filters the display of data for specific iPBridge
subsystems when in EventLog mode. If enabled for a
particular subsystem and level, that subsystem and level
is masked when the command EventLog is issued.
Subsystem entries: ................ Log level entries:
....... SCSI ................................. INFO
....... ENET ................................ WARN
....... GEN .................................. CRIT
....... NVRAM .............................. FAIL
....... PERF ................................ ALL
....... ECC
....... ALL
....... HTTP
....... iSCSI
....... NDMP
Default: disabled
Set syntax: set EventLogFilter [subsystem] [level]
[enabled|disabled]
Requires a SaveConfiguration command
Get syntax: get EventLogFilter [subsystem] [level]
Help
Displays a list of available commands. If command name
is specified, displays detailed command-specific
information.
Immediate command: Help [command name]
IdentifyBridge
Enabling this option causes the Fault LED on the front
panel of the iPBridge 2500D to blink until the parameter
is disabled.
Default: disabled
Set syntax: set IdentifyBridge [enabled|disabled]
Get syntax: get IdentifyBridge
Info
Displays version numbers and other production
information for key components within the iPBridge.
Immediate command: Info
iSCSITargetNameDisplay
Displays the iSCSI target name. If Multiple Target mode
is enabled, iSCSI target names are listed for all existing
iSCSI targets.
Immediate command: iSCSITargetNameDisplay
IsReserved
Displays the reservation status of the current iPBridge
session/interface.
If set, the configuration image is being modified by
another iPBridge services session: set commands are
temporarily unavailable but information commands are
available.
Executing a SaveConfiguration,
RestoreConfiguration or FirmwareRestart
RELEASES the iPBridge so that other services users may
access it.
When iPBridge services interface is RESERVED, set
commands from other users are unavailable.
At least one interface must always have access to the
iPBridge.
Immediate command: IsReserved
NDMPStatus
Shows status of all NDMP devices. The device name is not
mutually exclusive, i.e., the same name may apply to a
mover and tape/SCSI service at the same time.
DeviceName: device connection name
Port: Ethernet port number [0|1]
Types: tape, SCSI
Host: IP address of host connection
State for Tape: idle, listen, active, paused or halted
State for SCSI: idle, busy
Immediate command: NDMPStatus