ATTO Technology 2500C - Manual (Page 48)

39
ATTO Technology Inc. iPBridge Installation and Operation Manual
7.1.2 General use commands
These CLI commands are used in a variety of situations
Help
Displays a list of available commands. If a command
name is specified, displays detailed command-
specific information.
Immediate command: Help [command name]
Password
Specifies a password for all sessions: NDMP, telnet,
FTP and ExpressNAV web-based interface. A
prompt asks for the current password, to enter the
new password, and to confirm the new password.
Passwords are case sensitive, 0-32 characters with
no spaces. An empty password can be configured by
entering the Password confirmation prompts with
no parameters. The command
RestoreConfiguration default sets the password
to its default value.
Default: Password
Set syntax: set Password
Requires a SaveConfiguration command
ReadOnlyPassword
Specifies a read only password for all sessions:
NDMP, telnet, FTP and ExpressNAV web-based
interface. A prompt asks for the current password, to
enter the new password, and to confirm the new
password. Passwords are case sensitive, 0-32
characters with no spaces. An empty password can
be configured by entering the Password
confirmation prompts with no parameters. The
command RestoreConfiguration default sets the
password to its default value.
Default: Password
Set syntax: set ReadOnlyPassword
Requires a SaveConfiguration command
ReadOnlyUsername
Specifies a read only user name for all telnet, FTP
and ExpressNAV web server sessions. Username is
case insensitive, 1-32 characters with no spaces.
Default: user
Set syntax: set ReadOnlyUsername [username]
Requires a SaveConfiguration command
Get syntax: get Username
RestoreConfiguration
Restores configuration to either the default
configuration or the configuration last saved into
non-volatile memory. The saved option undoes any
changes made since the last save.
Immediate command: RestoreConfiguration
[Default | Saved]
SaveConfiguration
Many commands require a SaveConfiguration
command to be executed indicated by the return
Ready. *
When you invoke SaveConfiguration, the current
configuration is permanently saved in the iPBridge
and the new configuration becomes the active
configuration.
If a firmware restart is required to make the
requested change permanent, a prompt asks you to
confirm the restart. You can override this request by
indicating the override value on the command line.
You may make several changes through commands
and SaveConfiguration before implementing the
restart, but once you have restarted the iPBridge, all
the command changes created before the restart and
save are implemented. If you select the restart
option, the iPBridge executes its complete start up
cycle.
Restart or no Restart parameter is optional
Immediate command: SaveConfiguration <Restart |
NoRestart>