ATTO Technology 2500C - Manual (Page 57)

48
CLI
SpeedWrite
When enabled, improves the performance of WRITE
commands to SCSI devices attached to the iPBridge.
Specify SCSI bus (sb), target (st), LUN (sl) of a mapped
SCSI device or (all) for each currently mapped device
Set syntax: set SpeedWrite scsi [sb st sl | all] [enabled |
disabled]
Get syntax: get SpeedWrite scsi [sb st sl | all]
SpeedWriteDefault
When enabled, SpeedWrite performance enhancement is
set as the default for any subsequent SCSI devices
mapped manually or via an AutoMap operation. If
disabled, the iPBridge does not attempt SpeedWrite
performance enhancement to newly-mapped SCSI
devices.
Default: disabled
Set syntax: set SpeedWriteDefault [enabled | disabled]
Get syntax: get SpeedWriteDefault
VirtualDriveResponse
Allows the iPBridge to provide proxy responses to SCSI
INQUIRY and TEST UNIT READY commands if a SCSI
device selection times out or is busy. Host systems can
then assign devices consistently regardless of the device’s
state during the execution of the commands.
Default: disabled
Set syntax: set VirtualDriveResponse [enabled | disabled]
Get syntax: get VirtualDriveResponse