ATTO Technology 2500C - Manual (Page 61)

52
CLI
Ping
Sends an ICMP echo request to the specified host.
Immediate command: ping [DPn | MPn] [xxx.xxx.xxx.xxx]
<count <size>>
ReadOnlyPassword
Specifies a read only password for all sessions: NDMP,
telnet, FTP and ExpressNAV web-based interface. A
prompt asks for the current password, to enter the new
password, and to confirm the new password. Passwords
are case sensitive, 0-32 characters with no spaces. An
empty password can be configured by entering the
Password confirmation prompts with no parameters. The
command RestoreConfiguration default sets the
password to its default value.
Default: Password
Set syntax: set ReadOnlyPassword [password]
Requires a SaveConfiguration command
RMON
RMON collects and stores Ethernet data on data ports at
specified intervals. You can display the entire table
requested, or a single entry based on the index.
Entries in the Ethernet History table are not valid when
their Sample Index is 0.
Setting the history control entries take effect immediately,
but changes must be saved to be persistent over a reboot.
Valid range for EthernetStat index: 1-3
Valid range for historyControl and EthernetHistory
index: 1-6
Valid range for historyControl buckets requested: 1-
180
Valid range for historyControl interval: 1-3600
Default historyControl table (buckets and interval in
hexadecimal): Refer to Exhibit 7.1-8 below.
Set syntax: set RMON idx bucketsRequest interval [valid
| invalid]
Get syntax for entire table: get RMON [ethernetStat |
historyControl] <idx>
Get syntax for single index entry: get RMON
ethernetHistory <idx sampleIdx>
Username
Specifies a user name for all telnet, FTP and ExpressNAV
web server sessions. Username is case insensitive, 1-32
characters with no spaces.
Changes to the Admin Level
user name requires an Admin Level password.
Default: root
Set syntax: set Username [username]
Requires entering a password
Requires a SaveConfiguration command
Get syntax: get Username
ReadOnlyUsername
Specifies a read only user name for all telnet, FTP and
ExpressNAV web server sessions. Username is case
insensitive, 1-32 characters with no spaces.
Default: user
Set syntax: set ReadOnlyUsername [username]
Requires a SaveConfiguration command
Get syntax: get ReadOnlyUsername
Exhibit 7.1-8 Default history Control table (buckets and interval in hexadecimal) for the RMON CLI
command.
Idx DataSrc BktReq BktGrant Interval Owner Status
====================================================================
001 43.6.1.2.1.2.2.1.1.1 00000032 00000032 0000001e monitor 00000004
002 43.6.1.2.1.2.2.1.1.1 00000032 00000032 00000708 monitor 00000004
003 43.6.1.2.1.2.2.1.1.2 00000032 00000032 0000001e monitor 00000004
004 43.6.1.2.1.2.2.1.1.2 00000032 00000032 00000708 monitor 00000004
005 43.6.1.2.1.2.2.1.1.3 00000032 00000032 0000001e monitor 00000004
006 43.6.1.2.1.2.2.1.1.3 00000032 00000032 00000708 monitor 00000004