ATTO Technology 2500C - Manual (Page 54)

45
ATTO Technology Inc. iPBridge Installation and Operation Manual
Ping
Sends an ICMP echo request to the specified host.
Immediate command: Ping [DPn | MPn] [xxx.xxx.xxx.xxx]
<count <size>>
RMON
RMON collects and stores Ethernet data on data ports at
specified intervals. You can display the entire table
requested, or a single entry based on the index (and
sample index for the Ethernet History table).
Entries in the Ethernet History table are not valid when
their Sample Index is 0.
Setting the history control entries take effect immediately,
but changes must be saved to be persistent over a reboot.
Valid range for EthernetStat index: 1-3
Valid range for historyControl and EthernetHistory
index: 1-6
Valid range for historyControl buckets requested: 1-
180
Valid range for historyControl interval: 1-3600
Default historyControl table (buckets and interval in
hexadecimal): Refer to Exhibit 7.1-8 on page 52
Set syntax: set RMON idx buckets Request interval [valid
| invalid]
Get syntax for entire table: get RMON [ethernetStat |
historyControl] <idx>
Get syntax for single index entry: get RMON
ethernetHistory <idx sampleIdx>
RouteDisplay
Displays a list of host protocol to SCSI address mappings
on the bridge.
For NDMP, displays a list of NDMP name to SCSI Bus,
Target, LUN mappings. The optional name parameter
limits the list to the maps which satisfy a search for the
given name.
NumEntries: decimal number of map lines displayed
Name: 32-character NDMP device name
type: NDMP map type, either Tape or SCSI
sb: decimal SCSI bus number
st: decimal SCSI target number
sl: decimal SCSI LUN number
Immediate command: RouteDisplay NDMP <Name>
For iSCSI:, displays a list of iSCSI to SCSI Bus, Target,
LUN mappings. If Multiple Target mode has been
enabled, the optional Target Name parameter limits the
list to the maps which satisfy a search for the given target
name. In either mode, the optional LUN parameter limits
the list to the map which satisfies a search for the given
LUN.
NumEntries: decimal number of map lines displayed
Target Name: target name
Lun : target LUN
sb: decimal SCSI bus number
st: decimal SCSI target number
sl: decimal SCSI LUN number
Immediate command, single target mode:
RouteDisplay iSCSI <lun>
Immediate command, multiple target mode:
RouteDisplay iSCSI <Target Name> <lun>
SCSIPortList
Returns a list of available SCSI ports and their current
status. Valid status returns are O.K. and Failed.
Immediate command: SCSIPortList
SCSITargets
Returns a list of SCSI devices operational on the
referenced SCSI port.
Immediate command: SCSITargets [sb]
SerialNumber
Reports the serial number which is unique for each
iPBridge. The serial number tracks the board throughout
its life and should not be changed for any reason. Set form
requires operator privileges.
Information only: get SerialNumber
SNMPDumpMIB
Dumps the contents of the ATTO FibreBridge private
SNMP MIB to the current CLI session. Consult your
network administrator for further assistance with SNMP.
Immediate: SNMPDumpMIB
SNMPExtendedTraps
Controls Extended SNMP map functioning such as device
transition and device error. Consult your network
administrator for further assistance with SNMP.
Set syntax: set SNMPExtendedTraps [enabled|disabled]
Get syntax: get SNMPExtendedTraps