American Dryer Non-Tilting Phase 5 ML-200 - Manual (Page 13)

9
SECTION III
INSTALLATION PROCEDURES
Installation in a proper location should be performed by competent technicians in accordance with local and
state codes. In the absence of these codes, the installation must conform to applicable American National
Standards: ANSI Z223.1-LATEST EDITION (National Fuel Gas Code) or ANSI/NFPA NO. 70-LATEST
EDITION (National Electrical Code) or in Canada, the installation must conform to applicable Canadian Standards:
CAN/CGA-B149.1-M91 (Natural Gas) or CAN/CGA-B149.2-M91 (L.P. Gas) or LATEST EDITION (for General
Installation and Gas Plumbing) or Canadian Electrical Codes Parts 1 & 2 CSA C22.1-1990 or LATEST EDITION
(for Electrical Connections).
A. REASSEMBLY OF DRYER
IMPORTANT: Always keep the tumbler (basket) section of the dryer in an upright position when
moving it.
The ML-200 (gas model dryer) may be shipped
one of two ways; as a complete unit fully as-
sembled and ready for hookup or in two (2)
pieces with the middle frame separated from
the base. At installation, the middle frame will
be lifted onto the base. Use cables through
the eye bolts on top of the middle frame for
lifting. Fasten the middle frame to the base by
using the four (4) #3/8-16 bolts provided with
the unit. Also, reconnect the V-belts, belt guard
at the rear end of the unit, and reconnect the
electrical plugs located in the front control
boxes.
The ML-200 (steam models) can also be
shipped with the middle frame separated from
the base. In this case, follow the instructions
for reassembly of the gas dryer. The steam
dryer may also be shipped with the steam coil
and damper piston removed. If this is the case,
lift the steam coil on top of the middle frame,
with the steam connection pipes facing the right
side of the unit, and bolt the coil to the top of
the middle frame using the #3/8-16 bolts pro-
vided. Also, bolt the damper piston and sole-
noid valve to the top of the middle frame using
the bolts provided. There are three (3) panels
that cover the front, right side, and rear of the
steam coil. Fasten these in position.