ADTRAN MX2800 M13 - Manual (Page 148)

9-24 61200290L1-1G
Section 9, Transaction Language 1 (TL1) MX2800 M13 Multiplexer User Manual
Table 9-8 contains entries that are used to edit or retrieve options for the DSX portion of the MX2800.
When performing TL1 edit commands from this table, the value of rr should be T1, and the <aid> value
should be one of the following:
101 - DS1#1
102 - DS1#2
.
.
.
128 - DS1#28
Table 9-8. TL1 Editing Data Dictionary for DS1
Keyword Type Domain Description
DIAGDSXTESTSTATE ENUM One of the following:
• DATAMODE
• TRIBUTARY
• ANALOGNET
• DIGNET
• CODEC
• REMLPBK
• CSULPBK
• CSUBERT
• LINEBERT Identifies DSX Diagnostic Loopbacks.
Choose an available loopback
• Refer to
Data Mode on page 6-2
• Refer to Tributary on page 6-2
• Refer to Analog Network on page 6-3
• Refer to Digital Line/Net on page 6-3
• Refer to Codec Line/Net on page 6-4
• Refer to Remote Loopback on page 6-4
• Refer to CSU Loopback on page 6-4
• Refer to CSU Loopback w/BERT on
page 6-4
• Refer to Line BERT on page 6-5
DSXCAISRLY Y/N Y or [N] Identifies status of DSX CAIS alarm relay.
• Yes (Y) - enables alarm
• No (N) - disables alarm
DSXCFGLINESWPROT ENUM One of the following:
• DISABLE
• ENABLE
• UNAVAIL Identifies the state of the DSX Switch
Protection
• DISABLE - the switch is disabled
• ENABLE - the switch is enabled
• UNAVAIL - the switch is not in the
configuration