Next Advance SP1070-M - Manual (Page 4)

NEXT>>>ADVANCE www.nextadvance.com
SP1000 series operator’s manual
Manual SP1000 series iii
LP:nn- Defined Loop end and Loop Repetitions (“nn” times). Like LP:En, except that you indicate the
number of times the series will loop.
Note: You can create a loop within a loop (up to 3 layers deep)
PS:nn- Pause Pumping for nn seconds. A decimal point can be added between “nn” by holding down the
right-most arrow button. You can make the pause longer than 99 seconds by putting the pause function in a
program loop.
If nn is 00, the program will pause until you press “Start/Stop”- it will then resume with the next phase.
IF:nn- Jump to Phase If External Trigger. This conditionally alters the Pumping Program’s execution
based on an external signal (received through TTL I/O)
Et:nn-Event trigger Jump- Phase jump is triggered through falling edge delivered through foot pump
connected to TTL-I/O, or the RS-232 ‘RUN E’ command. See pump manual for more details.
ES:nn-Event Square Wave Trigger jump Phase. Phase jump is triggered through either falling edge
delivered through foot pump connected to TTL-I/O, or the RS-232 ‘RUN E’ command. See pump manual
for more details.
Et:rS- Event reset- cancels previously set event trap
Tr:aa-Override Operational Trigger Configuration. Overrides the default setup TTL- I/O operational
trigger configuration
OUT.n-Set TTL Output pin. If “n”=0, the output pin will be set low. If “n”=1 the output pin will be set
high.
bEEP- Sounds a short beep
To insert a phase into an already existing program-
Select the phase after you want your phase inserted (e.g., if is to be inserted in between phase 25 and 25,
select phase 25). Use the two left most arrow buttons to switch PH to In. Press the “Rate” button before
the 2 second time out.
To delete a phase –
Select the phase you want deleted. Use the two left most arrow buttons to switch PH to De. Press the
“Rate” button before the 2 second time out.
PUMP RESET:
Press and hold the right-most arrow key while turning on power to
the pump.