Next Advance SP1070-M - Manual (Page 48)

NEXT>>>ADVANCE www.nextadvance.com
SP1000 series operator’s manual
Manual SP1000 series 41
10.4.2 Pump Operational Commands
START PUMPING PROGRAM
RUN [ <phase data> ]
[E [<phase data> ] ]
Starts the Pumping Program operation.
If the Pumping Program was paused, then the Pumping Program resumes at the point where it was
stopped. Otherwise, the Pumping Program starts from Phase 1.
If a Phase number is specified (<phase data>), then the Pumping Program will start at the specified
Phase number.
The pump cannot be started if an alarm condition exists.
E [ <phase data> ]
Trigger a Pumping Program Event.
Triggers a pre-defined event defined with the Pumping Program’s Event function, causing an
immediate jump to the Pumping Program Phase defined by the event function.
If <phase data> is specified, the program will immediately jump to the Pumping Program Phase
specified by <phase data>, and cancel any other event set by the Pumping Program.
STOP PUMPING PROGRAM
STP
If the Pumping Program is operating, the pump will be stopped and the Pumping Program will be
paused.
If the Pumping Program is paused, the stop command will cancel the pause and reset the Pumping
Program to Phase 1.
VOLUME DISPENSED
DIS
Queries volume dispense only. Set not applicable.
Response:
I <float> W <float> <volume units>
Where: “I <float>“ refers to the infusion volume dispensed, and “W <float>” refers to the
withdrawn volume.
CLEAR VOLUME DISPENSED
CLD { INF | WDR }
Sets the Infused or withdrawn volume dispensed to 0. Command is only valid while the Pumping
Program is not operating. Query is not applicable.
INF = Infusion volume
WDR = Withdrawn volume
Query is not applicable.
10.4.3 Configuration and Setup Commands
New settings for any of the following commands will be stored in the non-volatile memory.
ALARM SETUP
AL [ <on-off> ]
Set/query alarm setup mode. Set alarm enables or disables alarm buzzer mode.