Revolabs Solo Executive Operation Manual - Manual (Page 11)

- 8 -
Installing the Solo Executive Base Station
The Revolabs Solo™ Executive Base Station is designed to be installed into a
standard 19” AV rack system using the attached rack ears.
To setup the Base Station:
1. Plug the power cord into an appropriate outlet.
2. Turn the fuse-protected power switch on the back panel to Reset.
The GREEN power LED on the front panel will illuminate.
3. Attach the diversity antennas (4 or 2 SMA female connectors) and the
smaller System Mute antenna (SMA RP male connector) in the center.
Understanding Revolabs Solo™ Executive Connections
There are eight 3.5mm mini-Phoenix input and output ports on the back panel
of the unit (four on the 4-channel system) providing access to each channel’s
audio signal.
The provided mini-Phoenix connectors are designed for easy wiring. The three
terminals (from left to right) correspond to positive +, negative -, and shielded
ground .
To connect the Solo Executive
1. Use the screws on top of the connector to first loosen the terminals.
2. Insert an appropriate 3 conductor cable (3 separate conductors, or 2
conductors and shield) into the terminals.
3. Tighten the screw to secure the cable.
4. Push the connector onto the pins centered under the desired input or
output port until firmly secured.