Revolabs Solo Executive Operation Manual - Manual (Page 17)

- 14 -
3. With the microphone in the wearing position, un-mute the microphone by
pressing and releasing the Mute button (confirm by viewing flashing GREEN
LED). If the volume is too low, move the microphone closer to the mouth.
4. To turn microphones off, return the microphone unit to the Charger Base or
press and hold the Mute button for ~10 seconds until the LED turns solid
RED and release button.
If the microphones are moved out of range of the Base Station (~100 feet or 30
meters) the connection will be dropped (LED flashes all colors) and the
microphone will mute.
After 15 seconds the microphone will beep 5 times, and will continue beeping
every 30 seconds to remind the user to return the microphone to the
conference room. If the microphone is moved back into range within 15
minutes the connection will automatically be re-established to its original state,
and the beeping will cease. If not, the microphone will turn off.
Adjusting the Volume on the Wearable Microphone Earpiece
To change the volume on the Wearable microphone earpiece, use the dial on
the earpiece wire.
Turning the dial towards the earpiece, as shown in the figure, will increase
the volume, and turning the dial towards the microphone will decrease the
volume. Use the attached clothing clip to secure the earpiece wire.
Using Solo Tabletop Wireless Boundary Microphones
The Solo TableTop Wireless Boundary Microphones enable multiple conference
attendees to use a single microphone.
The TableTop Wireless Microphone, shown on the following page, is designed to
provide optimum coverage when placed on a conference room table.