Revolabs Solo Executive Operation Manual - Manual (Page 27)

- 24 -
3. Release the button after the channel LED flashes green twice for reduced
power level 2. Release the button after the channel LED flashes green three
times for reduced power level 3. The power levels will continue to cycle
through the settings until the button is released.
4. Repeat steps 1 to 3 with the CHANNEL 4 button
5. Repeat steps 1 to 3 with the CHANNEL 6 button (8 channel system only)
6. Repeat steps 1 to 3 with the CHANNEL 8 button (8 channel system only)
When the base station is powered-on again, the LEDs will give one green flash
on channels 2, 4, 6, and 8 to indicate that the system is in high power mode,
twice to indicate reduced power level 2, and three times for reduced power level
3.
Note: Always confirm that all transceivers are set at the same power level
setting. Each channel will repeat the flash 10 times to indicate setting when
powered on, so make sure all odd channels flash the same number of times on
the unit.
Note: An Executive Single Channel can not be used in the same installation
with an Executive multichannel system because there is no way to synchronize
the units to prevent mutual signal interference.